Installation steps for the first use of a hands-free mop

The installation steps for the first use of a hands-free mop are relatively simple and usually include the following steps:

Check accessories:

Open the package and check whether the various parts of the mop are complete, including the mop rod, mop head, cleaning fluid, etc.

Confirm whether each part is damaged, if damaged, contact the business in time to replace.

Prepare tools:

Obtain a screwdriver. Some mops may need to be used during installation.

To assemble the mop rod:

Remove the mop rod from its packaging and inspect it for damage.

If the mop bar consists of multiple sections, it is usually necessary to rotate the sections together. When rotating, you can hear a "click" sound, indicating a strong connection.

Some mop rods may need to be adjusted in length to accommodate different heights and cleaning needs. When adjusting, follow the instructions to operate.

Install mop head:

Remove the mop head from its packaging and inspect it for damage.

Depending on the specific design of the mop, the fixing ring of the mop head is placed on the base of the mop rod, or the mop head is connected to the mop rod using a buckle.

If necessary, use a screwdriver to tighten the screws and ensure that the mop head is securely secured.

For some designs, it may be necessary to press the round hole of the mop head into the clip slot and ensure that the clip is secure.

Add cleaning solution (if applicable) :

Open the lid of the mop head and locate the cleaning liquid tank.

Add proper amount of cleaning solution according to the instructions, be careful not to overfill, so as not to overflow.

Adjust the balance (if applicable) :

If the mop head feels unbalanced after installation, you can adjust the balance screw.

Use a screwdriver to gently adjust the screws until the mop head is balanced.

Check the installation:

After installing the mop head on the mop rod, check whether it is secure.

Shake the mop gently to make sure the parts are tightly connected and not loose.

Trial mop:

Before use, you can use the mop to gently wipe on the wet ground to check the cleaning effect and flexibility of the mop.

If it is found that the mop is shaking or the cleaning effect is not good, it should be checked and adjusted in time.

During installation, ensure that the mop rod and mop head are clean and dust-free to avoid affecting the cleaning effect.

When tightening the screws, pay attention to moderate force to avoid damaging the parts.

When adding the cleaning solution, please follow the instructions to avoid waste or injury.

Before use, it is recommended to read the instruction manual of the mop to understand the characteristics and use of the product.

With the above steps, you can easily complete the initial installation of the hands-free mop and start enjoying a convenient cleaning experience.